Spectra Watermakers
Spectra Watermakers H. P. FILTER HOUSING WRENCH FT-FHW-10H
$3.00
Manuals & support
Start with your model’s parts diagram and the number on the installed part. Match any model, controls, voltage, or serial-range notes shown in this listing.
Spectra / Katadyn manufacturer support ↗Overview
Overview
FT-FHW-10H is the black service wrench in Spectra’s chart for the black-head high/low-pressure housing group. It is used to open the corresponding bowl during filter and seal service.
The chart distinguishes this tool from the older standard FT-FHW-10 wrench and from the blue wrenches for three-piece housings. Compare the housing profile before choosing a tool merely labeled “10-inch.”
Specifications & Contents
Specifications & Contents
| Part number | FT-FHW-10H |
|---|---|
| Housing chart group | FT-FTH-10H / FT-FTH-10L |
| Product scope | Filter-housing service wrench |
| Matching group seal | SO-FHS-10H |
Fits My System
Fits My System
For the black-bowl FT-FTH-10H or charted clear-bowl FT-FTH-10L, compare this wrench with the installed housing. The same chart also shows FT-FHW-10HSS as a separate stainless-steel tool in the high-pressure group.
Manuals & Resources
Manuals & Resources
Filter Housing Reference
Filter Housing Reference
Identify the housing by its part number before choosing its seal or wrench. This chart compares housing hardware; it does not establish that every cartridge fits every housing.
| Housing | O-ring | Wrench | Identification note |
|---|---|---|---|
| FT-FTH-10L3PCS | SO-FHS-3PCS10 | FT-FHW-3PCS | Three-piece low-pressure housing |
| FT-FTH-10 | SO-FHS-LP10 | FT-FHW-10 | Legacy standard housing and wrench marked discontinued in the chart |
| FT-FTH-10L, FT-FTH-10H, KIT-HPHASSEM | SO-FHS-10H | FT-FHW-10H, FT-FHW-10HSS | Low-pressure, high-pressure and dual high-pressure housings shown in chart |
| FT-FTH-10BC3PC1 | SO-FHS-3PS20BB | FT-FHW-20BB3PCS | Chart code differs from store FT-FTH-10BC3P1; housing identity unresolved |
Spectra filter, housing, seal and wrench chart. The chart’s 10-3/4-inch housing label is not a measured cartridge length. Match cartridge length, outside diameter, media and end seals separately.
