Spectra Watermakers
Spectra Watermakers 50 MICRON FILTER ELEMENT FT-FTC-50
$15.00
Manuals & support
Start with your model’s parts diagram and the number on the installed part. Match any model, controls, voltage, or serial-range notes shown in this listing.
Spectra / Katadyn manufacturer support ↗Overview
Overview
Cartridge length × outside diameter: Approximately 9.75 × 2.5 inches. Retained store dimensions; not independently measured. Nominal size classes may differ from measured end-to-end dimensions.
FT-FTC-50 is the 50-micron element identified in Spectra’s filter chart. The chart lists it separately from the 5- and 20-micron elements and from the carbon cartridge.
The 50-micron rating identifies a filtration grade; it is not a chlorine-removal specification. Match the installed cartridge number and the filter stage specified by the system manual.
The separately listed FT-FTC-50BB is a Big Blue cartridge. A shared micron number alone does not establish the same physical fit.
Specifications & Contents
Specifications & Contents
| Part number | FT-FTC-50 |
|---|---|
| Manufacturer filtration designation | 50 microns |
| Component | Filter element |
| Length × outside diameter | Approximately 9.75 × 2.5 inches; Retained store dimensions; not independently measured |
Fits My System
Fits My System
The separately listed FT-FTC-50BB is a Big Blue cartridge. A shared micron number alone does not establish the same physical fit.
Select your configuration to see its requirements, or open the complete reference below.
All documented configurations and requirements
Each group applies only to the listed configurations and installed hardware. Match the conditions and manufacturer references before ordering.
Documented configurations
- Catalina 300 · MPC 5000 · Match installed voltage and hardware
For the documented original configuration; match installed filter stages, housing and strainer dimensions if modified. Confirm the quantity needed for your repair.
Documented configurations
- Newport 1000 · MPC 3000 · Match installed voltage and hardware
- Newport 700 · MPC 3000 · Match installed voltage and hardware
For the documented original configuration; match installed filter stages, housing and strainer dimensions if modified. Confirm the quantity needed for your repair.
Documented configurations
- Newport 400 · MPC 5000 · Match installed voltage and hardware
For the documented original configuration; match installed filter stages, housing and strainer dimensions if modified. Confirm the quantity needed for your repair.
Manuals & Resources
Manuals & Resources
Filter Housing Reference
Filter Housing Reference
Identify the housing by its part number before choosing its seal or wrench. This chart compares housing hardware; it does not establish that every cartridge fits every housing.
| Housing | O-ring | Wrench | Identification note |
|---|---|---|---|
| FT-FTH-10L3PCS | SO-FHS-3PCS10 | FT-FHW-3PCS | Three-piece low-pressure housing |
| FT-FTH-10 | SO-FHS-LP10 | FT-FHW-10 | Legacy standard housing and wrench marked discontinued in the chart |
| FT-FTH-10L, FT-FTH-10H, KIT-HPHASSEM | SO-FHS-10H | FT-FHW-10H, FT-FHW-10HSS | Low-pressure, high-pressure and dual high-pressure housings shown in chart |
| FT-FTH-10BC3PC1 | SO-FHS-3PS20BB | FT-FHW-20BB3PCS | Chart code differs from store FT-FTH-10BC3P1; housing identity unresolved |
Spectra filter, housing, seal and wrench chart. The chart’s 10-3/4-inch housing label is not a measured cartridge length. Match cartridge length, outside diameter, media and end seals separately.
