Spectra Watermakers
Spectra Watermakers PRESSURE TRANSDUCER CABLE EL-SSR-PSH
$30.00
Manuals & support
Start with your model’s parts diagram and the number on the installed part. Match any model, controls, voltage, or serial-range notes shown in this listing.
Spectra / Katadyn manufacturer support ↗Overview
Overview
EL-SSR-PSH is the pressure-sensor cable shown alongside the EL-SSR-150 transducer in the legacy Catalina parts drawing. It carries the sensor connection; the transducer itself is a separate part.
Identify the cable ends and the board/sensor arrangement on the installed system. The drawing does not establish its length, pinout or use with every Spectra pressure sensor.
Specifications & Contents
Specifications & Contents
| Part number | EL-SSR-PSH |
|---|---|
| Component | Pressure-transducer cable |
| Documented example | Legacy Catalina, beside EL-SSR-150 |
Fits My System
Fits My System
Identify the cable ends and the board/sensor arrangement on the installed system. The drawing does not establish its length, pinout or use with every Spectra pressure sensor.
Select your configuration to see its requirements, or open the complete reference below.
All documented configurations and requirements
Each group applies only to the listed configurations and installed hardware. Match the conditions and manufacturer references before ordering.
Documented configurations
- Catalina 300 · MPC 5000 · Match installed voltage and hardware
item in the identified generation and enclosure. Match switch poles/terminals, boot or enclosure dimensions, and instrument range/connection as applicable. A similar label on another control generation is not a substitution.
Documented configurations
- Newport 400 · MPC 5000 · Match installed voltage and hardware
item in the identified generation and enclosure. Match switch poles/terminals, boot or enclosure dimensions, and instrument range/connection as applicable. A similar label on another control generation is not a substitution.